This site uses cookies. Due to the new EU regulations this message appears on your first visit.


Flexline exists of the following modules that can be combined into any desired production line:
  • iX 502 – high passive and small IC outputs up to 121,000 cph
  • iX 302 - high passive and small IC outputs up to 79,000 cph
  • iFlex T4 – Dual and single lane solution with high passive and small IC (up to 17,5 x 17,5mm) outputs up to 51,000 cph
  • iFlex T2 - Dual and single lane multifunctional or line-balancing solution with large component range
  • iFlex H1 – Dual and single lane end-of-line solution with oddform and gripper capabilities

    Flexline with KNS.jpg



The three available modules are:
iFlex T4: Chip and IC shooting from 0402M (01005) to 17.5 x 17.5 x 15 mm at 51,000 cph (IPC9850(A))
iFlex T2: Chip and IC shooting from 0402M (01005) to 45 x 45 x 15 mm at 24,000 cph (IPC9850(A))
iFlex H1: End-of-line placer placing up to 120 x 52 x 35 mm at 7,100 cph (IPC9850(A))

iX 502/iX 302
Scalable output - High first pass yield




The unique placement process features:

  • Advanced PCB collision detection mechanism ('when does the component touch the board')
  • No impact force = No component cracking
  • Real-time closed-loop placement force control to place the part at the specified placment force
  • Placement process verification (according blue-print value)  - Always check the reliablilty of each individual placement
  • PCB surface mapping allows all other placement heads to place without impact on the learned placement height.


  • Conceptually smooth machine movement: low maintenance, reliable component handling and a continuous basis for accuracy, 24 hours a day, 7 days a week - year after year.
  • Fully software controlled pick and place cycle: controlled pick, optimum acceleration and deceleration process, monitoring and controlled placement: No damage to components.
  • All individucal placements follow 'blue-print' values, making sure only correct PCBs leave the line.
  • Proven reliability of fewer than 1 defect per million placement performance.
  • Capacity can be added or removed in order to increase or decrease output without altering the line footprint: True capacity on demand.


Copyright © by ICCO EMT Kft. 2015. 

All Rights Reserved.